The ALU-Z PROFESSIONALWARM heating mats are designed specifically for this use!

Features and benefits
- Only 2.8mm thin
- 100 W/m² power
- Aluminum coated for homogeneous heat distribution
- Sleeveless
- Easiest installation
- Maintenance-free
- Suitable for boats and yachts
Do you have any questions or like to place an order?
General questions
07135/98 98 0 or office@hemstedt.de
Question about our products
inquiries@hemstedt.de
Orders
orders@hemstedt.de
Perfect warmth for any room
The Hemstedt ALU-Z mats have been specially developed for the use as underfloor heating under parquet or laminate. An aluminum coating ensures a very homogeneous distribution of the heat.
Low energy consumption
Since the ALU-Z heating mats are laid directly under the floor covering, the heating effect is very direct, which means that already with a minimum of electric power the pleasant heating effect of a floor heating can be achieved.
Easy installation
Installation is extremely simple: The room is, as usual, covered with an acoustic insulation. The ALU-Z mat is rolled directly on it. The laminate or parquet goes directly on the ALU-Z, finish. The extremely low thickness of the ALU-Z mats of just 2.8 millimeters make them ideal for underfloor heating in restorations and renovations. No underfloor heating with water and pipes can keep with that!
Ideal for allergy-sufferers
All those who suffer from allergies, must pay attention to the choice of the floor covering. Thanks to the Hemstedt ALU-Z heating mat nobody has to forgo an underfloor heating. Hemstedt offers the right underfloor heating for any flooring. So allergy-sufferers can benefit from the dust and dust mites blocking advantage of an underfloor heating in any room.
Optimized
Of course, not only the heating mat has been specially developed. The temperature sensors and controllers have been tailored to the ALU-Z underfloor heating in order to always ensure the perfect indoor climate with maximum energy efficiency.


Specifications ALU-Z PROFESSIONALWARM Item no. 30600
Nominal voltage | 230 Volt |
Output | 100 W/m² |
Cold connection cable | 1 x 2.5 m and 1 x 6.00 m |
Min. installation temperature | 5°C |
Min. bending radius | 6 x dA |
Resistance tolerance | -5 %/+10 % |
Standard | 60335-2-96 |
Cold/warm splice | sleeveless, without shrinkable sleeve |
Heating cable diameter | ca. 2.8 mm |
Insulation | Fluorplastic |
Delivery width | 0.45 m |
Calculation width | 0.50 m |